• If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


No announcement yet.

Axigen 10 bugged after restore

  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    Thank you, I will try this when I have my internship done

    I have a question about Fail2Ban, i did exactly what was stated in the how-to (post 8) and it is loggin auth pass and failure but not banning.

    This is the error :
    root@mail:/etc/fail2ban/filter.d# sudo service fail2ban restart
    * Restarting authentication failure monitor fail2ban WARNING 'filter' not defined in 'axigen'. Using default one: ''
    ERROR Failed during configuration: Bad value substitution:
    section: [axigen]
    option : action
    key : port
    rawval : ", protocol="%(protocol)s", chain="%(chain)s"]

    Made the filter in /etc/fail2ban/filter.d and added axigen to the config file


    • #17
      I have the same problem with fail2ban.